[Apr 02, 2023] 350-801 Dumps PDF and Test Engine Exam Questions - Real4Prep
Verified 350-801 exam dumps Q&As with Correct 196 Questions and Answers
NEW QUESTION 36
Refer to the exhibit.
An engineer must modify the existing QoS policy-map statement to implement LLQ for voice traffic. Which change must the engineer make in the configuration?
- A. bandwidth 170 to LLQ 170
- B. bandwidth 170 to reserve 170
- C. bandwidth 170 to percent 170
- D. bandwidth 170 to priority 170
Answer: C
NEW QUESTION 37
Refer to the exhibit.
An administrator is attempting to register a SIP phone to a Cisco UCM but the registration is failing. The IP address of the SIP Phone is 10.117.34 222 and the IP 1 address of the Cisco UCM is 10.0.101.10. Pings from the SIP phone to the Cisco UCM are successful. What is the cause of this issue and how should it be resolved?
- A. An NTP mismatch is preventing connection of the TCP session between the SIP phone and the Cisco UCM. The SIP phone and Cisco UCM must be set with identical NTP sources.
- B. An network device is blocking TCP port 5060 from the SIP phone to the Cisco UCM. This device must be reconfigured to allow traffic from the IP phone.
- C. The certificates on the SIP phone are not trusted by the Cisco UCM. The SIP phone must generate new certificates.
- D. DNS lookup for the Cisco UCM FQDN is failing. The SIP phone must be reconfigured with the proper DNS server.
Answer: B
NEW QUESTION 38 
Refer to the exhibit A user takes a phone from San Francisco to New York for a short reassignment. The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern in a route list that contains the Standard Local Route Group. To where does the call retreat?
- A. The call egresses in New York because the device automatically is assigned a New York device pool and uses the local gateway
- B. The call fails because device mobility is turned on. and the phone is not configured in New York The engineer must configure which sites the device should be roaming to
- C. The call fails because the Standard Local Route Group is being used only if no configuration is set for the device pools
- D. The call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco
Answer: D
NEW QUESTION 39
An engineer is configuring Cisco Jabber for Windows and must implement desk phone control mode for some of the users. Which access control group must be configured for those users to enable this functionality?
- A. Standard CTI Secure Connection
- B. Allow Control of Device from CTI
- C. Standard CTI Enabled
- D. Standard CTI Allow Reception of SRTP Key Material
Answer: B
NEW QUESTION 40
Multiple router patterns match a number. How does Cisco Unified Communications Manager determine which pattern to use?
- A. the one that comes first in numerical order
- B. the one with the longest match
- C. the one with the closed match
- D. the one that discards everything PreDot
Answer: C
NEW QUESTION 41
A collaboration engineer configures Global Dial Plan Replication for multiple Cisco UCM clusters. The local cluster acts as the hub cluster and the remaining clusters act as spoke clusters. Which service must the engineer configure on the local cluster?
- A. Mobility Cross Cluster
- B. Intercluster Lookup Service
- C. Location Conveyance on intercluster SIP trunks
- D. intra-Cluster Communication Signaling
Answer: D
NEW QUESTION 42
What is the major difference between the two possible Cisco IM and Presence high-availability modes?
- A. Balanced mode provides user load balancing and user failover only for manually generated failovers.
Active/standby mode provides an unconfigured standby node in the event of an outage, but it does not provide load balancing. - B. Balanced mode provides user load balancing and user failover in the event of an outage. Active/standby mode provides an always on standby node in the event of an outage, but it does not provide load balancing.
- C. Balanced mode does not provide user load balancing, but it provides in the event of an outage. Active/ standby mode provides an always on standby node in the event of an outage, but it does not provide load balancing.
- D. Balanced mode provides user load balancing and user failover in the event of an outage. Active/standby mode provides an always on standby node in the event of an outage, and it also provides load balancing.
Answer: B
Explanation:
Section: Collaboration Applications
NEW QUESTION 43
A remote office has a less-than-optimal WAN connection and experiences packet loss, delay, and jitter. Which VoIP codec should be used in this situation?
- A. iLBC
- B. G.722.1
- C. G.711ulaw
- D. G.729A
Answer: D
Explanation:
Section: Protocols, Codecs, and Endpoints
Explanation/Reference: https://community.cisco.com/t5/collaboration-voice-and-video/summary-of-cucm-supported-codecs/ ta-p/3162905
NEW QUESTION 44
A customer wants a video conference with five Cisco Telepresence 1X5000 Series systems. Which media resource is necessary in the design to fully utilize the immersive functions?
- A. Cisco Webex Meetings Server
- B. Cisco PVDM4-128
- C. Cisco Meeting Server
- D. software conference bridge on Cisco UCM
Answer: C
NEW QUESTION 45
Which application traffic does the DiffServ AF41 class according to the Cisco Collaboration System Solution Reference Network Design?
- A. audio call
- B. video call
- C. messaging
- D. signalling
Answer: B
NEW QUESTION 46
Refer to the exhibit.
A collaboration engineer needs to replace the original, single NTP server that was configured during the initial install of a Cisco UCM server What is the first step to accomplish this task?
- A. Restart the NTP service on Cisco UCM.
- B. Delete the original NTP server from Cisco UCM
- C. Stop the NTP service on Cisco UCM.
- D. Enable NTP authentication for the new NTP server on Cisco UCM.
Answer: B
NEW QUESTION 47
Refer to the exhibit. Which outgoing m-line SDP is sent to Cisco UCM after matching the appropriate dial peers via Cisco Unified Border Element?
- A.
- B.
- C.
- D.
Answer: A
NEW QUESTION 48
An engineer configures local route group names to simplify a dial plan. Where does the engineer set the route groups according to the local route group names that are configured?
- A. route pattern
- B. CSS
- C. device pool
- D. route list
Answer: D
Explanation:
Section: Call Control
NEW QUESTION 49
Which three parameters are requested in an Audit Endpoint message from a Cisco Unified CM to an endpoint on a MGCP gateway? (Choose three.)
- A. Observed Events
- B. Request Identifier
- C. Capabilities
- D. Connection Parameters
- E. Call ID
- F. Bearer Information
- G. Connection Mode
- H. Connection ID
Answer: B,C,H
NEW QUESTION 50
A presence redundancy group is deployed, and an engineer with ID012345678 initiates a Manager fallback.
Which statement about Cisco server Recovery Manager is true?
- A. disconnects all user that had been failed over
- B. disconnects all users that had been failed over, and the users must log in again
- C. restart the Cisco Presence Engine
- D. restarts critical services on the secondary node
Answer: B
NEW QUESTION 51
What dialed number match this cisco UCM route pattern?
1[23]XX
- A. 12300 through 12399 only
- B. 1200 through 1399 only
- C. 1200 through 1300 only
- D. 1230 through 1239 only
Answer: B
NEW QUESTION 52
According to the QoS Baseline Model, drag and drop the applications form the left onto the correct per-Hop Behaviour values on the right.
Answer:
Explanation:
NEW QUESTION 53
Which protocol does prime collaboration Assurance use to poll the health status of different systems in the collaboration environment?
- A. SNMP
- B. SCCP
- C. SMTP
- D. SIP
Answer: A
NEW QUESTION 54
Which two approaches are taken to implement CAC within Cisco UCM in full-mesh topology?
(Choose two.)
- A. physical location
- B. Audio Codec Preference List
- C. RSVP-enabled locations
- D. location-based CAC
- E. device pool
Answer: C,D
Explanation:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmsys/CUCM_BK_ SE5FCFB6_00_cucm-system-guide-100/CUCM_BK_SE5FCFB6_00_cucm-system-guide-
100_chapter_01000.html
NEW QUESTION 55
......
Cisco 350-801 Test Engine PDF - All Free Dumps: https://www.real4prep.com/350-801-exam.html
Get New 350-801 Certification – Valid Exam Dumps Questions: https://drive.google.com/open?id=1IfDM8m_LjvA75zAzIMoqv2SP0xgOmF9g