Master 2021 Latest The Questions HPE Product Certified and Pass HPE2-W09 Real Exam!
Penetration testers simulate HPE2-W09 exam PDF
NEW QUESTION 20
Is this a best practice when positioning ArubaOS-CX switches in data center networks?
Solution: Deploy Aruba CX 83xx switches as data center spine switches.
- A. No
- B. Yes
Answer: B
NEW QUESTION 21
Refer to the exhibit.
Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISL between Switch-1 and Switch-2. enable Equal Cost Multi Path (ECMP) on both Switch-1 and Switch-2.
- A. No
- B. Yes
Answer: A
NEW QUESTION 22
A customer's servers use ISCSI, and they send data and storage traffic on the same pair of I OGbE links. Is this a best practice for supporting the ISCSI requirements?
Solution: Set up dedicated switches to connect to iSCSl arrays. Connect top of rack (ToR) switches, which will support both data and storage traffic, to those dedicated switches.
- A. No
- B. Yes
Answer: B
NEW QUESTION 23
Refer to the exhibits.
Is this how the switch handles the traffic?
Solution: A frame with destination MAC address, 00:50:56:15:16:28, arrives with a VLAN 10 tag on 1/1/1 on Switch-1. Switch-1 encapsulates the frame with VXLAN and an IP header destined to 192.168.1.2.
- A. No
- B. Yes
Answer: A
NEW QUESTION 24
Is this a requirement for implementing Priority Flow Control (PFC) on an ArubaOS-CX switch interface?
Solution: configuring trust of Cos on the interface
- A. No
- B. Yes
Answer: B
NEW QUESTION 25
Refer to the exhibit.
You need to set up an ArubaOS-CX switch to implement Virtual Extensible LAN (VXLAN) WITHOUT Ethernet VPN (EVPN). The exhibit Indicates which servers should be part of the same VXLANs and the desired VNls for the VXLANs. Assume that the network is already configured to permit each ArubaOS-CX switch to reach each other switch's loopback interface.
Is this part of the process for setting up VXLAN to meet the requirements?
Solution: On Switch-1, set 192.168.1.3 as a peer IP address in the VNI 5020 context.
- A. No
- B. Yes
Answer: A
NEW QUESTION 26
Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: ensures a minimum bandwidth guarantee between two endpoints traffic with various 802.1 p values.
- A. No
- B. Yes
Answer: A
NEW QUESTION 27
Does this correctly describe how the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?
Solution: The ISL and keepalive goes down, and after a few seconds, the keepalive link restores. Switch-l and Switch-2 remains up. The Split-recovery mode is enabled. In this case the secondary switch shutdowns SVls when keepalive is restored.
- A. No
- B. Yes
Answer: A
NEW QUESTION 28
An ArubaOS-CX is \ssmq DCBX on Interface 1/1/1. You enter this command:
show dcbx interface 1/1/1
Is this where you can see whether the connected converged network adapter (CNA) has accepted the application priorities advertised with DCBX?
Solution: in the Enhanced Transmission Selection (ETS) Local advertisement section
- A. No
- B. Yes
Answer: B
NEW QUESTION 29
Refer to the exhibit.
You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add a route with this command: ip route 10.1.20.0/24 vlan20 vrf A
- A. No
- B. Yes
Answer: A
NEW QUESTION 30
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Combine multiple links between two data centers into link aggregations (but not multi-chassis ones).
- A. No
- B. Yes
Answer: A
NEW QUESTION 31
Is this a way that a data center technology can help meet requirements for multi-tenancy?
Solution: Virtual Extensible LAN (VXLAN) enables multiple isolated Layer 3 domains, each with its own routing table, to share a physical network.
- A. No
- B. Yes
Answer: A
NEW QUESTION 32
Refer to the exhibit.
which shows the topology tot an Ethernet Ring Protection Switching (ERPS) solution.
Is this a valid design for the control and protected VLANs on the VSX fabric 1 switches?
Solution: Ring l, instance 1:
control VLAN: 1000 protected VLANs: 51-135 Ring 1, Instance 2:
control VLAN: 1000 protected VLANs: 136-220 Ring 2, Instance 1: control VLAN: 1001 protected VLANs: 181 -200 Ring 2, Instance 2: control VLAN: 1001 protected VLANs: 201 -220
- A. No
- B. Yes
Answer: B
NEW QUESTION 33
Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: to help the switch to look inside tunneled traffic and apply different quality of service (QoS) settings to different types of traffic
- A. No
- B. Yes
Answer: A
NEW QUESTION 34
Is this how you should position switches in the ArubaOS-CX portfolio tor data center networks?
Solution: Deploy Aruba 83xx switches as core switches for very large three-tier data center networks.
- A. No
- B. Yes
Answer: A
NEW QUESTION 35
Does this correctly describe the ArubaOS-CX architecture?
Solution: The AtubaOS-CX software is based on the ArubaOS-Switch software and adds data center features.
- A. No
- B. Yes
Answer: A
NEW QUESTION 36
Refer to the exhibit.
Refer to the exhibit.
You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add VRF B as the secondary VRF on VLAN interface 30.
- A. No
- B. Yes
Answer: A
NEW QUESTION 37
Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer (AFC) is integrated with Nutanix?
Solution: Automated provisioning of LAGs Between AHV and VSX
- A. No
- B. Yes
Answer: A
NEW QUESTION 38
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Inside a configuration plan, light-click any device-specific parameters and modify the parameter per-device.
- A. No
- B. Yes
Answer: A
NEW QUESTION 39
Refer to the exhibits.
Is this how the switch handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.2. but not 192.168.1.3.
- A. No
- B. Yes
Answer: B
NEW QUESTION 40
......
Penetration testers simulate HPE2-W09 exam: https://www.real4prep.com/HPE2-W09-exam.html
Bestselling On-The-Job Reference Exam Questions: https://drive.google.com/open?id=1hxxaMON_ik8f6txBEc7Kfa7uoeM4EWRa