Pass NS0-176 Exam in First Attempt Guaranteed 2021 Dumps!
NS0-176 Dumps Full Questions - Exam Study Guide
NEW QUESTION 26
Which three elements are included in a UCS service profile? (Choose three.)
- A. server definition
- B. firmware revisions
- C. identity information
- D. volume layout
- E. switch configuration
Answer: A,B,C
NEW QUESTION 27
You want to run the FlexPod execution profile in NetApp Config Advisor.
Which three login credentials are required to perform this task? (Choose three.)
- A. UCS Manager
- B. NetApp support login
- C. Nexus switches
- D. ESXi server
- E. NetApp cluster
Answer: A,C,E
NEW QUESTION 28
Exhibit:
You have a FlexPod solution with vSphere ESXi. When you click the icons shown in the exhibit, you do not see any network connectivity details.
Which Cisco UCS policy type should you create to enable visibility of these details?
- A. Link Profile Policy
- B. LAN Connectivity Policy
- C. Link Protocol Policy
- D. Network Control Policy
Answer: B
NEW QUESTION 29
Which two are characteristics of a Fibre Channel SAN data LIF? (Choose two.)
- A. It can be associated with an IP address.
- B. It can be associated with an Ethernet port or VLAN interface.
- C. It can be associated with an interface group (ifgrp).
- D. It is associated with the management LIF.
- E. It can be associated with a WWPN.
- F. It can be associated with a Fibre Channel port.
- G. It is associated with the administrative Vserver.
Answer: E,F
NEW QUESTION 30
How are jumbo frames enabled on the Nexus 5548?
- A. system qosmtu 9216
- B. system mtu jumbo 9000
- C. system jumbo-frame
- D. policy-map type network-qos JUMBOclass type network-qos class-defaultmtu 9216system qosservice-policy type network-qos JUMBO
- E. policy-map type queueingclass type queueing class-defaultmtu 9216
Answer: D
NEW QUESTION 31
An administrator has a FlexPod solution with VMware vSphere 6.0. The VMware environment is using FCoE for storage connectivity for datastores.
Virtual machines running Windows Server 2012 R2 and RHEL have a requirement to use RDM LUNs for virtual machine storage. The administrator created an RDM LUN for a Windows 2012 R2 virtual machine and is currently creating an initiator group to map the LUN.
In this situation, which operating system should the administrator select for the initiator group?
- A. Linux
- B. VMware
- C. Windows
- D. Open VMS
Answer: C
NEW QUESTION 32
Refer to the exhibit.
When configuring a Cisco UCS B-Series server to support boot from SAN in a FlexPod deployment, which statement is correct?
- A. This configuration will support boot from SAN
- B. Boot from SAN is not supported in a FlexPod environment
- C. This given configuration will not support a local ESXi installation
- D. This configuration will not support boot from SAN.
Answer: D
NEW QUESTION 33
Refer to the exhibit.
Which is correct for configuring FCoE?
- A. fcoe vsan 43int po21switchport trunk allowed vsan add 43vsan databasevsan 43
- B. fcoe vsan 43int po11switchport trunk allowed vsan add 43vsan databasevsan 43
- C. fcoe vlan 33int po11switchport trunk allowed vlan add 33vsan databasevsan 33
- D. vlan 33fcoe vsan 43int po21switchport trunk allowed vsan add 43int vfc11bind interface po21vsan databasevsan 43 interface vfc 11
- E. vlan 33fcoe vsan 43int po11switchport trunk allowed vlan add 33int vfc11bind interface po11switchport trunk allowed vsan 43vsan databasevsan 43 interface vfc11
Answer: E
NEW QUESTION 34
An administrator has a FlexPod solution using VMware vSphere 6.0. The ESXi hosts use iSCSI for storage connectivity, and all paths have been configured and connected between the NetApp cluster and the ESXi hosts.
Virtual Storage Console has been installed and ESXi host-recommended settings have been applied to all hosts. The active LUN path for one of the iSCSI datastores experiences a connectivity failure and the LUN switches to a new active path.
In this scenario, which event would trigger the ESXi host to switch the active LUN path again?
- A. The ESXi host scans for new VMFS datastores.
- B. The NetApp LIF is reverted to its home port.
- C. The original LUN path comes back online.
- D. The host processes 1,000 I/O operations.
Answer: B
NEW QUESTION 35
While working on a performance related issue on your FlexPod solution, you notice an unequal distribution of traffic over the physical interfaces of a four port vPC between two Nexus 5000 switches. You would prefer a more even traffic distribution.
Which command would you use to accomplish this task?
- A. ~lacp rate fast~
- B. ~port-channel load-balance ethernet~
- C. ~hardware multicast hw-hash~
- D. ~lacp system-priority~
Answer: B
NEW QUESTION 36
Which feature allows Cisco Nexus 7000 Series switches to be virtualized at the device level?
- A. VDC
- B. VLAN
- C. VRF
- D. PONG
Answer: A
NEW QUESTION 37
Which three actions are required to configure two Cisco Nexus switches as vPC peers? (Choose three.)
- A. Create a peer link between switches.
- B. Enable the vPC feature.
- C. Configure matching vPC domain IDs.
- D. Modify the network QoS policy.
- E. Configure different vPC domain IDs for each switch.
Answer: A,C,D
NEW QUESTION 38
Which statement is true about NFS exports in Clustered Data ONTAP?
- A. Export policies and rules need to be set at the data Vserver level.
- B. Export policies and rules need to be set at the data Vserver level and export policies are created and modified by editing /etc/exports on the node with the share.
- C. Exports can be either persistent or temporary.
- D. Export policies are created and modified by editing /etc/exports on the node with the share.
- E. Exports can be either persistent or temporary, and export policies and rules need to be set at the data Vserver level.
Answer: A
NEW QUESTION 39
After deploying a FlexPod solution, which tool would you use to validate a successful installation?
- A. Config Advisor
- B. UCS Manager
- C. Hardware Universe
- D. System Manager
Answer: A
NEW QUESTION 40
Your customer has the storage configuration for a FlexPod solution shown below.
- FAS8040 HA-pair
- Disk stack one-4x DS4243 disk shelves (2TB SATA disk drives)
- Disk stack two- 2x DS 2246 disk shelves (1.2TB disk drives)
- There are no unused SAS ports on either controller
- There are no expansion slots available on either controller
The customer wants to attach a single DS2246 disk shelf with 800 GB SSD drives.
In this scenario, what are two ways to connect the new shelf for optimal performance? (Choose two).
- A. Cable a new stack for the SSD shelf.
- B. Cable the new shelf to the end of stack one.
- C. Cable the new shelf to the end of stack two.
- D. Cable the new shelf to the beginning of stack two.
Answer: A,D
NEW QUESTION 41
An administrator has a FlexPod solution configured for Microsoft Hyper-V 2012 R2. The hypervisor will be using CIFS shares for Cluster Shared Volume (CSV) datastores. A storage virtual machine (SVM) is configured, and a CIFS share is created for use.
When attempting to add the CSV datastore to the CIFS share, an error occurs and the datastore is not created.
Which three steps should the administrator perform to solve the problem? (Choose three.)
- A. Configure the export policy with the Hyper-V host IP address.
- B. Configure the ~-smb3-enabled~ parameter on the SVM.
- C. Create multiple LIFs for CIFS Hyper-V traffic to enable ALUA.
- D. Enable the "Continuous Availability" setting on the CIFS share.
- E. Configure the "Enable Oplocks" setting on the CIFS share.
Answer: A,B,E
NEW QUESTION 42
To install your VEM, what is the extension of the VEM file name you'll be looking for to complete this install?
- A. .vib
- B. .vsm
- C. .vem
- D. .zip
Answer: A
NEW QUESTION 43
Given the following switch output, where would you expect see notification level messages?
N5K-1# show logging info.
Logging console: enabled (Severity: error)
Logging monitor: enabled (Severity: informational)
Logging linecard: enabled (Severity: emergency)
Logging fex: enabled (Severity: notifications)
Logging time stamp: seconds
Logging server: disabled
Logging logfile: enabled
- A. Notification messages will not be seen anywhere
- B. On the linecard
- C. On the terminal sessions
- D. On the console
Answer: C
NEW QUESTION 44
In which two locations is the VSAN ID configured in a FlexPod solution? (Choose two.)
- A. UCS Manager
- B. hypervisor adapter
- C. Nexus switches
- D. Storage Virtual Machine
Answer: A,C
NEW QUESTION 45
......
Cisco and NetApp FlexPod Free Certification Exam Material from Real4Prep with 141 Questions: https://www.real4prep.com/NS0-176-exam.html