Pass Your Fortinet Exam with NSE7_SDW-6.4 Exam Dumps (Updated 37 Questions)
NSE7_SDW-6.4 Exam Dumps - Fortinet Practice Test Questions
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
NEW QUESTION 11
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )
- A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
- B. FEC transmits additional packets as redundant data to the remote device.
- C. FEC improves reliability which overcomes adverse WAN conditions such as noisy links.
- D. FEC transmits the original payload in full to recover the error in transmission.
- E. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss
Answer: B,C
NEW QUESTION 12
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It ensures route tags match the SD-WAN rule based on the rule order
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- D. It tags each route and references the tag in the routing table.
Answer: A
NEW QUESTION 13
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. On the hub VPN, only the device needs additional phase one sett
- B. Each VPN device has a unique pre-shared key configured separately on phase one
- C. The protected subnets should be set to address object to all (0.0 .0. o/o).
- D. ADVPN should only be enabled on unmanaged FortiGate devices.
Answer: B
NEW QUESTION 14
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Shared policy shaping mode
- B. Reverse policy shaping mode
- C. Per-IP shaping mode
- D. Interface-based shaping mode
Answer: D
NEW QUESTION 15
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. Each VPN device has a unique pre-shared key configured separately on phase one.
- B. ADVPN should only be enabled on unmanaged FortiGate devices.
- C. On the hub VPN, only the device needs additional phase one settings.
- D. The protected subnets should be set to address object to all (0.0.0.0/0).
Answer: A
Explanation:
Explanation/Reference:
NEW QUESTION 16
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Configure SD-WAN rules interface preference.
- B. Select SD-WAN balancing strategy.
- C. Specify incoming interfaces in SD-WAN rules.
- D. Specify outgoing interface routing cost.
Answer: A
NEW QUESTION 17
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify outgoing interface routing cost.
- B. Configure SD-WAN rules interface preference.
- C. Select SD-WAN balancing strategy.
- D. Specify incoming interfaces in SD-WAN rules.
Answer: A,B
NEW QUESTION 18
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. The 10 Mbps bandwidth is shared equally among the IP addresses.
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
NEW QUESTION 19
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on portl that match only FIRSTJVPN.
Which two configuration changes must be made to both IPsec
VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two )
- A. Use unique Diffie Hellman groups on each VPN interface
- B. Configure a unique peer ID for each dial-up VPN interface
- C. Use different proposals are used between the interfaces.
- D. Configure the IKE mode to be aggressive mode
Answer: B,D
NEW QUESTION 20
Refer to exhibits.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)
- A. All the existing sessions will be blocked from using port1 and port2.
- B. All the existing sessions that do not use SNAT will be flushed and routed through port1.
- C. All the existing sessions using SNAT will be flushed and routed through port1.
- D. All the existing sessions will continue to use port2, and new sessions will use port1.
Answer: C,D
NEW QUESTION 21
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- B. A factory reset performed on FortiGate.
- C. The zero-touch provisioning process has completed internally, behind FortiGate.
- D. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- E. The FortiGate cloud key has not been added to the FortiGate cloud portal.
Answer: C,E
NEW QUESTION 22
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology
Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )
- A. London generates an IKE information message that contains the Toronto public IP address
- B. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- C. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN
- D. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
Answer: B,C
NEW QUESTION 23
Which components make up the secure SD-WAN solution?
- A. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- B. Datacenter, branch offices, and public cloud
- C. Telephone, ISDN, and telecom network.
- D. Application, antivirus, and URL, and SSL inspection
Answer: D
NEW QUESTION 24
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Shared policy shaping mode
- B. Reverse policy shaping mode
- C. Interface-based shaping mode
- D. Per-IP shaping mode
Answer: A
NEW QUESTION 25
Which statement is correct about the SD-WAN and ADVPN?
- A. Spoke support dynamic VPN as a static interface.
- B. Dynamic VPN is not supported as an SD-Wan interface.
- C. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
- D. ADVPN interface can be a member of SD-WAN interface.
Answer: D
NEW QUESTION 26
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. The packet exceeded the configured bandwidth and was dropped based on the priority configuration
- B. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
- C. Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.
- D. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
Answer: C
NEW QUESTION 27
Which statement is correct about the SD-WAN and ADVPN?
- A. Spoke support dynamic VPN as a static interface.
- B. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
- C. ADVPN interface can be a member of SD-WAN interface.
- D. Dynamic VPN is not supported as an SD-Wan interface.
Answer: D
NEW QUESTION 28
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. FortiGate created a single IPsec virtual interface that is shared by all clients
- B. There are separate virtual interfaces for each dial-up client
- C. VPN static routes are prevented from populating the FortiGate routing table
- D. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
Answer: B
NEW QUESTION 29
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- C. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It acts as a policy compliance entity to review all managed FortiGate devices.
Answer: B,E
NEW QUESTION 30
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Dead members require manual administrator access to bring them back alive
- B. Port2 might become alive when a single response is received from an SLA server
- C. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
- D. SD-WAN interface becomes disabled and port1 becomes the WAN interface
Answer: C
NEW QUESTION 31
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The dead member interface stays unavailable until an administrator manually brings the interface back.
- B. Check interval is the time to wait before a packet sent by a member interface considered as lost.
- C. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
- D. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
Answer: C
NEW QUESTION 32
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- B. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- C. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- D. Both SD-WAN member interfaces have used separate SLA targets.
Answer: A
NEW QUESTION 33
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The web filter profile must be enabled on the firewall policy
- B. The URL category must be specified on the traffic shaping policy
- C. The application control profile must be enabled on the firewall policy.
- D. The shaper mode must be applied per-IP shaper on the traffic shaping policy
Answer: A
NEW QUESTION 34
Which statement reflects how BGP tags work with SD-WAN rules?
- A. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: A
NEW QUESTION 35
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
- D. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
Answer: C,D
NEW QUESTION 36
......
New Real NSE7_SDW-6.4 Exam Dumps Questions: https://drive.google.com/open?id=1nVXL9FPsOYIMIUlaIB0W3EKtZ2g_5nQQ
Pass Your NSE7_SDW-6.4 Exam Easily with Accurate PDF Questions: https://www.real4prep.com/NSE7_SDW-6.4-exam.html